failure in shear
英 [ˈfeɪljə(r) ɪn ʃɪə(r)]
美 [ˈfeɪljər ɪn ʃɪr]
剪切破坏，剪切损坏
双语例句
- However, at higher angle of tooth-shaped asperities and under higher normal stress, the failure model II is found, which is in first tension but final shear failure.
在较高的法向应力下，含起伏角较高齿形节理面的非贯通节理岩体可能出现破坏模式II（先张拉后剪切破坏模式）。 - The displacement mutation characteristics of monitoring points were chosen as the failure criteria of materials in the shear strength reduction method.
选择边坡内某些监测点的位移突变特征作为强度折减法的材料破坏判据。 - Scanning the micro-structure of soils taken from the failure surface when the soil samples reach failure state in the shear test ( including direct shear test and quick tri-axial shear test), the micro-structural images were gained.
其中在强度实验（直剪实验、三轴固结快剪实验）中，当土体达到剪切破坏时，取破裂面上的土样，进行电镜扫描，得到微结构图像； - The phase of inter-collapse is the developing and enlarging process of soil-hole, that is the slow and gradual failure process of cover-layer soil, in which the soil failure form is composite failure with tensile failure and shear failure.
内部塌陷阶段是土洞发育与扩展即覆盖层岩土体逐渐破坏的缓变过程，土体的破坏为拉张破坏与剪切破坏相复合的混合破坏方式； - Analyses of the Failure Criteria of Masonry in Compression-Shear
对砌体剪-压破坏准则的研究 - The steel ratio at the bottom of a large beam should be restricted to avoid possible column failure in shear.
对于柱端剪切破坏应采用限制大梁底部纵向钢筋的方法予以避免。 - The information gained indicates that the spreading of the interface crack in tension field is intimately connected with failure in shear.
所得结果表明，拉伸场中界面裂纹的扩展和剪切失效有密切关系。 - Failure mechanics study of concrete in compression-shear stress field
压剪应力场中混凝土破坏机理的研究 - Standards from different countries adopt different failure mechanisms and do not take consideration of change of joint width in calculating shear strength in the vertical joint.
各国规范对其强度计算采用不同的破坏机理且不考虑接缝宽度变化的影响。 - The test had shown that under shear forces distinct brittle shear failure occured in the wall, and the wall exhibited higher shear bearing capacity and better deformation performance than that of reinforced concrete shearing wall.
试验表明在剪力作用下墙片会发生比较明显的的脆性剪切破坏，其抗剪承载能力较高，而且其变形能力比钢筋混凝土剪力墙的变形能力要好。 - And the phase of surface-collapse is a sudden varying process of surface ground soil failure and collapsing caused by the enlarging of critical soil-hole, in which the soil failure follows shear failure or tensile failure, the different failure style will causes the different shape collapse pit.
地表塌陷阶段是土洞扩张导致地表土体破坏塌落的突变过程，土体破坏为剪切破坏或拉张破坏，不同的破坏方式将在地表形成不同形状的塌坑。 - It is commen to cause baleful aftereffect for the composite laminated thin-walled structures buckling failure in shear.
复合材料层合结构在纯剪切载荷作用下会发生失稳破坏，造成灾难性的后果是常见的。 - At the same time, abnormal joints may be failure in the way of four modes, namely the first kind of failure mode: shear failure in small core area;
同时，异型中节点可能发生四类破坏，即第一类破坏模式：小核芯区域的剪切破坏； - During the deformation, disintegration and failure of debris-soil landslides, in space the plastic strain of the sliding mass and shear strength of the rock or soil mass on a sliding plane are different.
在碎石土滑坡变形解体破坏过程中，在空间上滑体塑性应变和滑面上岩土体抗剪强度的发挥程度是不一致的； - Debonding Failure Strength in RC Beams Strengthened with FRP for Shear
混凝土梁外贴FRP抗剪加固承载力计算 - Experimental investigation on failure wave in K9 glass under combined pressure and shear impact loading
压剪联合冲击下K9玻璃中的失效波 - Non-uniformity of the horizontal and vertical stresses stems from the localized failure in the pillar in the form of multiple shear bands.
应力分布的不均匀性，根源于矿柱发生了以多重剪切带为表现形式的局部剪切破坏。 - An Experimental Study on Progressive Failure of Tooth-shaped Asperity Joints in Direct shear
齿形节理渐进破坏直剪试验研究 - The Characteristics of rock failure and strength under tri-axial compressions is theoretically analyzed in detail with the twin shear theory and the results are compared with those of experiments which have been done.
应用双剪理论对岩石在三轴压缩载荷下的强度特性进行了较系统的理论分析，并将分析结果与已有实验作了对比。 - Joints failure mainly includes matrix failure and fiber-matrix shear failure. In the three failure modes of composite materials, matrix failure is greatly influenced by temperature, whereas fiber-matrix shear failure and fiber failure are not affected nearly by temperature.
接头破坏主要以基体失效和纤维基体剪切失效为主，在复合材料的三种失效模式中，基体失效受温度影响较大，纤维基体剪切失效和纤维失效基本不受温度影响。 - Through push-out test, the force characteristics, load-slippage rule, failure mechanism of single shear stud in joint section are studied, the shear capacity and shearing stiffness of single shear stud are calculated.
通过推出试验，研究分析了推出试件中单枚剪力钉的受力特性、荷载-滑移规律和破坏机理，计算分析了单枚剪力钉的抗剪承载力及剪切刚度。